SER DOT MATRIX LOP CARD

Description

• Supply voltage requirement 12VDC TO 24VDC.
• Single digit & double digit 1 inch Dot Matrix are available in the same card.
• This LOP card communicates with SER-3500 & SER-3200 Logic board using two wires MODBUS communication.
• SER DOT MATRIX LOP Card having UP & DOWN Hall Call with Registration LED connector, So we can use them in FULL COLLECTIVE & DOWN COLLECTIVE mode.
• Using a single switch we can set the floor of the SER DOT MATRIX LOP card.
• Setting for floor set as follows:

Press the setting switch for 2 Sec & then by each time we press & release the switch floor number shown on display it increases & after then when we reach our selected floor then don’t press the switch.

After 5 sec selected floor number blink 3 times & set as our selected LOP floor, then hall call & car call of that card act as that set floor hall & car call.

• Our other Main Logic board communicates with SER DOT MATRIX Card using EX-485 Card & it works as a Floor Indicator Display using two wires only. No floor set setting is required if it is used as only Floor Indicator display.
• If Elevator is in the Inspection mode then “M” is indicated instead of Arrow & that “M” scrolls in the direction elevator.
• Communication Fail is indicated with the “+” symbol in the floor display position. 
• DOT MATRIX & SQUARE MATRIX both options are available.
• Following Colors are available in SER DOT MATRIX Card
• -RED
• -WHITE